A close-up picture of garrison galvanized steel fence with dark gray color.

Dark gray galvanized steel fence.

We'd like to introduce the installation skills of galvanized steel fence from the tools, assemble and install methods of the fencing.

  • Operation requirement

    Get ready for the installation tools you need to use.

    A yellow steel tape used to install the garrison fence.

    Steel tape used for garrison fence installation

    Hexagonal wrenches used to install the garrison fence.

    Hexagonal wrenches used for garrison fence installation

    Dicing saw used to install the garrison fence.

    Dicing saw used for garrison fence installation

    Electric drill used to install the garrison fence.

    Electric drill used for garrison fence installation

    Check whether the accessories are complete according to the accessories list.

    There list part accessories used to install the garrison fence.

    Accessories used for garrison fence installation.

  • Railing assembly
    • The assembly site requires a flat carpet or paper cover to avoid the scratch of the product during assembly.

    • Cross rail and vertical picket connection

      • Put the vertical picket waterproofing cover in the prepunching hole of the horizontal rail, use the rubber hammer to tap, so that the cover is fixed on the horizontal rail.
      • Put the cross rails with waterproof ring as required fixed position.
      • Put the vertical pickets one by one through the square hole until the self-locking card locked. The hole of the vertical picket should be in the same direction as the hole on the horizontal rail.

    • Post and cross rails connection

      • Install the connection block on the post. The side post only holds a link block in one direction.
      • Locking stainless steel tamper screws on the connecting block.

    • Pipe and post connection

      • Draw the position of the fixed screw according to the drawing.
      • Connect the pipe to the base clip and tapping on the side with a rubber mallet.
      A close-up picture of steel pipe used to install the garrison fence.

      The pipe used for garrison fence installation

      A close-up picture of steel pipe and base clip used to install the garrison fence.

      Pipe and base clip used for garrison fence installation

  • Fence installation

    • Primary layer treatment

      There should be no shortening in the base concrete, and installation elevation should comply with the design requirements. The uneven surface must be removed or repaired. Cement mortar shall not be used to repair the serious honeycomb surface. Application of high-strength concrete repair, wait until there is a certain intensity before the railings can be installed.

    • Pipe fixed

      Draw the installation position according to the drawing and fasten it with the pop-rivet.

    • Post installation

      First, determine the position of the fixed point, and then punching with percussion drilling. Finally install and fix the expansion bolt. Note that this takes two people to complete. A person holds the post to make sure it stays upright, while another fasten all the screws.